| Sponsor |
|
6 Common Mistakes of BGA Rework
BGA rework is one of the most challenging procedures you may need to master. Doing it right depends in large part on the skills and knowledge of the rework technician. Learn more ...
Circuit Technology Center
|
|
Ultra-Low Voiding Halogen-Free No-Clean Lead-Free Solder Paste
The miniaturization trend is driving components with large pads. To alleviate the voiding challenge, a voiding-free solder paste will be the solution.
Materials Tech
DOWNLOAD
|
Authored By:
Li Ma, Fen Chen and Ning-Cheng Lee, Ph.D.
Indium Corporation
Clinton, NY, USA
Summary
The electronic industry is evolving rapidly toward miniaturization, with major emphasis on thin product profiles. This is particularly true for portable devices, such as smart phones. To facilitate the implementation of thin profile, use of thin components such as LGA and QFN becomes mandatory. This means the solder paste will have great difficulty in venting the volatiles at reflow due to the low standoff. In the case of QFN, due to the incorporation of large thermal pads, therefore a significantly higher difficulty for the escape of flux volatiles at reflow, formation of large voids virtually becomes inevitable. Apparently the presence of large voids will greatly jeopardize the reliability of devices.
While board design and process adjustment may alleviate the voiding challenge somewhat, an intrinsically voiding-free solder paste will be the most desirable solution. With the elucidation of voiding mechanisms and a deep understanding of the material factors contributing to the voiding, a new halogen-free, lead-free, and no-clean solder paste 44-29-3 was developed. The test results showed this paste was significantly lower in voiding than any other solder pastes tested in this study. It also exhibited nearly none solder beading, and a very acceptable performance on non-slump, wetting on OSP and ENIG under air, solder balling, and graping.
Conclusions
The miniaturization trend is driving industry to adopting low standoff components, including components with large pads. This resulted in large voids, and consequently jeopardized the reliability of devices. While board design and process adjustment may alleviate the voiding challenge somewhat, an intrinsically voiding-free solder paste will be the most desirable solution. With the elucidation of voiding mechanisms and a deep understanding of the material factors contributing to the voiding, a new halogen-free, leadfree, and no-clean solder paste 44-29-3 was developed. The test results showed this paste was significantly lower in voiding than any other solder pastes tested in this study. It also exhibited nearly none solder beading, and very acceptable performance on non-slump, wetting on OSP and ENIG under air, solder balling, and graping.
Initially Published in the SMTA Proceedings
|
Free Newsletter Subscription
Circuitnet is built for professionals who bear the responsibility of looking ahead, imagining the future, and preparing for it.
Insert Your Email Address
|
| Sponsor |
|
Fast PCBs, Fully Assembled
Need it fast? Summit delivers quick-turn PCB fabrication and assembly on compressed timelines—no shortcuts, just speed and precision from one source.
Summit Interconnect
|
|
|
