August 17, 2010 Solder Mask Contributing To Solder Balls Since you mention SMT lands, I will assume we are talking about SMT solder balls, not wave. In a word, yes ... F. B.
August 10, 2010 Test Your Knowledge In the "Test Your Knowledge" section of the newsletter, the question "How many nautical ... P. M.
August 10, 2010 SPC for Reflow Ovens The ideal is obviously to monitor the full time/temperature profile for every ... D. W.
August 2, 2010 Soldermask Insulation Issue The pcg needs to be re-engineering for the component to sit on the pads correctly. This should ...
July 22, 2010 Gold Plated Lead Discoloration Thank you so much for your expert views. Following is additional information ... C. T.
July 19, 2010 Options for Reducing Dross ALL possible options...? One option that is often overlooked is de-dross interval. Having conducted ... L. R.
June 17, 2010 Cape Canaveral/Cape Kennedy Technically, your trivia question regarding Cape Canaveral is incorrect. It was originally ... B. P.
June 10, 2010 What Causes Chip Component Blow Out This problem is limited to one specific component. Could this be a problem with moisture ... D. L.
May 21, 2010 Zinc in solder A comment about zinc in solder. The ultrasonic method of soldering to glass or ... P. V. P.
May 21, 2010 Cleaning No-Clean Solder Paste Maybe I missed it in this thread, but I am not clear why you would clean boards if using ... M. S.
